johnnydcusa
asked on
Can I restart server in middle of Background Initialization to start OS installation?
I have a Dell with 4 drive RAID 5. I lost the server when 2 drives went down.
So I put in 2 new drives and used the Perc Bios to rebuild the 4 disk RAID 5 Array and a logical drive.
It started a Background Initialization a few minutes later.
I have read that you can stop a BGI and it will restart again later. I want to start installing the OS ASAP but only if it is going to work successfully ;)
Can I stop the BGI, soft restart the server and start installing the OS and let the BGI start again so I can get on with my rebuild project?
So I put in 2 new drives and used the Perc Bios to rebuild the 4 disk RAID 5 Array and a logical drive.
It started a Background Initialization a few minutes later.
I have read that you can stop a BGI and it will restart again later. I want to start installing the OS ASAP but only if it is going to work successfully ;)
Can I stop the BGI, soft restart the server and start installing the OS and let the BGI start again so I can get on with my rebuild project?
ASKER
Thanks Andrew. But I had already read that information.
the article also states "Because the initialization is run in the background, other processes can continue while the initialization completes. "
Does this mean if I restart the machine and allow it to boot up to the OS CD it will start the BGI again but I can be going through the OS installation process at the same time as it does the BGI?
It has already been running a couple of hours; I have raid 5 on 4 x 73GB HD's.
Any thoughts?
the article also states "Because the initialization is run in the background, other processes can continue while the initialization completes. "
Does this mean if I restart the machine and allow it to boot up to the OS CD it will start the BGI again but I can be going through the OS installation process at the same time as it does the BGI?
It has already been running a couple of hours; I have raid 5 on 4 x 73GB HD's.
Any thoughts?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
You can only view the Initialization progress if you start it manually. If you wait over 5 mins (as I did while reading the documentation) it starts automatically to run BGI and I cannot see how far it has gone. Just saw a post on an HP site which said it took 4 hrs - but didn;t mention drive size ;(
I'll keep this open a little longer to see if there are any other substantive comments about this issue....
I'll keep this open a little longer to see if there are any other substantive comments about this issue....
Ya, keep it open for a few and see if anyone else has any ideas. Personally I would just wait it out. Go watch a movie or something and when you get back it should hopefully be done. Watching the screen right now is most likely like waiting for water to boil. Hopefully it will be done soon.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I spoke with Dell support on this before and according to the technician you can write data to the array as long as the BGI process has completed a higher percentage of the array than you are initially planning to use. In other words if you are installing an OS that will use 25GB on a 500GB array, then 5% of the BGI needs to be completed before starting the install. Once BGI is complete you can use the entire drive. We have performed this with 2950/1950/R710's with PERC 6/i and also with MD3000 arrays attached to PE Servers with no issue.
I got this from here:
http://support.dell.com/su
I hope this information helps. Good luck.